Large-format FDM, purpose-built for factory-floor tooling.
A 1,000 × 610 × 610 mm chamber heated to 95 °C, integrated material drying and four 4,100 cm³ spools with automatic changeover, so tooling, fixtures and end-of-arm tools print in-house, unattended for up to two weeks†.
† Stratasys claim (up to). Source: stratasys.com F870 page, read 10 Nov 2026.
Tooling in days, not weeks.
Integrated material drying
Regenerative drying bays keep filament print-ready.
4,100 cm³ spools
Four spools with automatic changeover, shared with the F3300.
Three print heads
N14 for detail, N20H for Nylon 12CF, N25 for up to 2× ASA throughput (Stratasys claim).
Tool-free head changes
Swap print heads without tools.
FDM Nylon 12CF
Lightweight, high-strength carbon-fibre parts.
F870 · StratasysIn-house tooling
Make fixtures and EOAT on site instead of outsourcing machining.
Long unattended runs
Up to two weeks between material changes (Stratasys claim).
Lower total cost
Fewer failed builds and less operator labour.
Scalable materials
Nine materials at launch on a spool format shared with the F3300.
F870 at a glance
- Build size
- 1,000 × 610 × 610 mm (39.4 × 24 × 24 in.), 372,000 cm³; diagonal 1,171 mm
- Layer thickness
- N14: 0.18, 0.25 or 0.33 mm · N20H: 0.25 mm · N25: 0.33 mm
- Throughput
- N14 up to 25 cm³/h · N20H up to 21 cm³/h · N25 up to 66 cm³/h (Stratasys figures)
- Accuracy
- XY ±0.254 mm or ±0.002 mm/mm; Z ±0.200 mm or ±0.002 mm/mm, plus 1 layer height (whichever is greater, 95 % dimensional yield)
- Materials
- FDM Nylon 12CF, ABS-M30 Black, FDM ASA (White, Ivory, Light Gray, Black, Red, Yellow), FDM ABS Draft (Gray)
- Support
- SR-35 soluble support
- Material delivery
- 4 × 4,100 cm³ spools, automatic changeover, integrated drying
- Software
- GrabCAD Print, Insight, MTConnect
- System size & weight
- 175 × 124 × 196 cm · 817 kg
- Power
- 3-phase, 208 V, 30 A; no shop air needed (integrated vacuum pump)
- Operating conditions
- 15–30 °C, 30–70 % RH; 99 cm clearance on each side
The tools your production line needs, made on site.
End-of-arm tooling, fixtures, gauges and ergonomic aids, printed in hours and replaced as the line changes.
End-of-arm tooling
Lightweight Nylon 12CF replacements for machined aluminium.
Fixtures, jigs and gauges
Assembly fixtures and check gauges made in-house.
Ergonomic aids
Operator-specific hand tools and lift assists.
Installation & commissioning
Site readiness checks, installation and acceptance by IME engineers.
Operator & DfAM training
Hands-on training for operators and designers, at AMIC or on-site.
Maintenance & support
Preventive maintenance, service contracts, spares and local technical support.
Other FDM systems
Get F870 pricing and expert guidance.
Talk to a specialist about your application. We’ll walk through pricing and a test print of your own part at AMIC.