Life-like anatomical models, on demand.
J850 and J5 Digital Anatomy print models that replicate the look, feel and response of human tissue. J5 MediJet adds biocompatible, sterilisable guides and multicolour models in a compact system.
Source: stratasys.com J850 Digital Anatomy, J5 Digital Anatomy and J5 MediJet pages, read 10 Nov 2026.
The look, feel and response of real tissue.
Digital Anatomy materials
TissueMatrix, BoneMatrix, GelMatrix and RadioMatrix.
300+ anatomy presets
Physician-tested, validated presets (J850 DA).
Full colour
Colour-coded anatomy for planning and teaching.
Biocompatible and sterilisable (MediJet)
Approved materials support steam, gamma, VHP and EtO sterilisation.
Compact J5 systems
Quiet, odour-free and facility-friendly.
Digital Anatomy · MediJet · StratasysPre-surgical practice
Rehearse procedures on patient-specific models.
Fewer cadaver and animal models
Repeatable training models on demand.
Cost
MediJet: 30 % lower cost per part than outsourcing (Stratasys claim).
Digital Anatomy · MediJet at a glance
- Models
- J850 Digital Anatomy, J5 Digital Anatomy, J5 MediJet
- Build size
- J850 DA: 490 × 390 × 200 mm · J5: 140 × 200 × 190 mm (1,174 cm² tray)
- Layer thickness
- J850 DA: 14 µm (High Quality, 7 materials), 27 µm, 54 µm · J5: down to 18 µm
- Accuracy
- J850 DA: ±100 µm under 100 mm; ±200 µm or ±0.06 % over 100 mm · J5: ±150 µm under 100 mm; ±0.15 % over 100 mm (rigid materials)
- Materials
- Digital Anatomy: TissueMatrix, BoneMatrix, GelMatrix, RadioMatrix · MediJet: MED615RGD, DraftWhite, Elastico, Digital ABS Plus
- Software
- GrabCAD Print (Digital Anatomy); Digital Anatomy Creator and GrabCAD Print Pro optional
- System size & weight
- J850 DA: 1,400 × 1,260 × 1,100 mm · 430 kg, plus material cabinet · J5: 651 × 661 × 1,511 mm · 228 kg
- Power
- J850 DA: 100–120 VAC 13.5 A or 220–240 VAC 7 A, 1 phase · J5: 100–240 VAC, 10 A, 1 phase
- Operating conditions
- 18–25 °C, 30–70 % RH non-condensing
- Compliance
- CE, FCC, EAC. The printers are not FDA-cleared medical devices.
Planning, training and device testing.
Point of care
Patient-specific models for surgical planning.
Medical device testing
Benchtop validation on realistic anatomy.
Education and research
Hands-on training and simulation, including dental presets.
Installation & commissioning
Site readiness checks, installation and acceptance by IME engineers.
Operator & DfAM training
Hands-on training for operators and designers, at AMIC or on-site.
Maintenance & support
Preventive maintenance, service contracts, spares and local technical support.
Other PolyJet systems
Get Digital Anatomy · MediJet pricing and expert guidance.
Talk to a specialist about your application. We’ll walk through pricing and a test print of your own part at AMIC.