Multi-material dental production.
Three PolyJet printers for dental labs: J3 DentaJet (up to three materials, countertop), DentaJet XL (two materials, 4 kg cartridges, high volume) and J5 DentaJet (up to five materials, TrueDent dentures and full-colour models).
Source: stratasys.com J3 DentaJet, DentaJet XL and J5 DentaJet pages, read 10 Nov 2026.
One tray, many cases.
Multi-material jobs
Models, guides and gingiva masks on one tray.
4 kg cartridges (XL)
Hot-swappable, fewer material changes.
Super High Speed (XL)
Up to 30 % faster for high volume (Stratasys claim).
Full colour and TrueDent (J5)
Monolithic dentures and shade-matched models.
GrabCAD Print
Set-up, monitoring and job management.
DentaJet series · StratasysMore capacity
Unattended, multi-material jobs.
Lower cost per part
Up to 67 % lower on DentaJet XL (Stratasys claim).
Low-touch operation
One technician can run several printers.
DentaJet series at a glance
- Models
- J3 DentaJet, DentaJet XL, J5 DentaJet
- Build size
- Print area 1,174 cm²; max part 140 × 200 × 190 mm
- Layer thickness
- Down to 18 µm; XL Super High Speed 61.875 µm (aligner arches)
- Materials per job
- J3: up to 3 · XL: up to 2 · J5: up to 5 (each plus support)
- Materials
- MED610-DSG Rigid Clear, MED620S Rigid Opaque, MED625FLX Flexible Clear, Elastico/VeroMagenta Flexible Pink, Vero White; J5 adds VeroVivid colours and TrueDent
- Support
- SUP711 (water-jet removable)
- Regulatory
- TrueDent: FDA-cleared Class II and CE-marked Class IIa; MED610-DSG: FDA-registered and CE-marked Class I (per Stratasys)
- System size & weight
- J3: 651 × 661 × 774 mm · 98 kg · XL: 651 × 661 × 1,511 mm · 199 kg · J5: 651 × 661 × 1,511 mm · 228 kg
- Software
- GrabCAD Print
- Network
- LAN, TCP/IP
- Power
- 100–240 VAC, 50–60 Hz, 10 A, 1 phase
- Operating conditions
- 18–25 °C, 30–70 % RH non-condensing
- Compliance
- CE, FCC, cTUVus, Industry Canada, RCM
From implant guides to monolithic dentures.
Implant cases and surgical guides
Clear, accurate guides with models and gingiva masks on one tray.
Models and aligners
Crown and bridge models and clear-aligner arches at volume.
TrueDent dentures (J5)
Monolithic, multi-colour dentures, partials and try-ins.
Installation & commissioning
Site readiness checks, installation and acceptance by IME engineers.
Operator & DfAM training
Hands-on training for operators and designers, at AMIC or on-site.
Maintenance & support
Preventive maintenance, service contracts, spares and local technical support.
Other PolyJet systems
Get DentaJet series pricing and expert guidance.
Talk to a specialist about your application. We’ll walk through pricing and a test print of your own part at AMIC.